DVS Atomix LT Guía de instalación descargar pdf (Pagina 43)

3-9

Installation

Connecting the GPI Panel

A 12-pin flat cable is used to make the connection of the GPI panel to

the board. The connector on the board is located on the rear side of the

expansion module. Set up the connection as shown in the following fig-

ure:

Figure 3-6: Internal connection of the GPI panel

Once all panels are properly connected to the Atomix LT board, you

have to continue the installation with the next step and set up the re-

maining internal connections.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 71 72

Sin comentarios

DVS Atomix LT Guía de instalación Pagina 43